Range Rover Discovery Ignition Wire STI
Fits:
Set of 8
1) 8mm Stunning Blue Wire with 3 layers of 100% pure silicone
2) Two layers of fiberglass braiding for unparalleled physical strength
3) Spiro-Wound Stainless Steel Conductor with extremely low resistance which allows maximum voltage "Firepower" to reach the spark plugs while preventing radio frequency noise (RFI) from interfering with onboard electrical equipment (i.e. radios, cellular phones, TVs etc.)
4) Rated over 100,000 volts in dielectric strength with continuous heat protection up to 600ºF
5) German Engineered, High Performance Plug Connectors sealed to the wire with High Temperature Viton heat shrink tubing
6) Made in USA
On
Discovery models it may be necessary to remove intake plenum to replace
ignition wires, if not wires will appear be too short. ERR 6621 intake
plenum gasket will be required. **No Longer supplied w/Ceramic
insolators, manufacturer has redesigned the Wire sets no longer
requirying Ceramic isolators or guide pieces*
